To align the Godex DT 4:
- Open the Devices & Printers folder.
- Right click the Godex printer & select Printer Properties
- Go to the Tools tab
- Click Actions then select Reset to Factory Defaults
- Then click Run calibration.
- The printer will feed several labels
If this does not work, try the following:
- Turn printer off
- Press & hold feed button
- Turn printer on while holding feed button
- Printer light will flash red & beep
- Release Feed button
- Note: The scanner head will read the size of the labels & align based on the label size in the printer. The printer will feed configuration labels while it aligns
If the printer does not have a cutter, ensure the cutter is turned off inside of Check-In.
- Inside of the Check-In application go to the Menu
- If the cutter is on the button will read “Turn Cutter Off”. Click it & it will change to "Turn Cutter On".
Updated